The Milo journal: short, practical write-ups on hardware, firmware and shipping connected products, from an engineering studio in Bar, Montenegro.

JournalNotes from the bench

Engineering notes.

Short, practical write-ups on hardware, firmware and shipping products — published a few times a week from the bench in Bar.

Latest · Process BOM cost estimation before your first prototype A practical approach to BOM cost estimation for connected devices: grouping parts, price breaks, hidden costs and contingency that hold up. Read — 6 min →
BOM cost estimation before your first prototype
46 posts

BOM cost estimation before your first prototype

A practical approach to BOM cost estimation for connected devices: grouping parts, price breaks, hidden costs and contingency that hold up.
Process 6 min

Battery compartment design for small electronics enclosures

Practical battery compartment design for small devices: cell tolerances, contacts, doors, swelling room and coin cell rules to settle early.
Design 7 min

RF range testing that predicts real-world coverage

How to plan RF range testing that predicts real coverage: link budgets, conducted checks, field methods and the mistakes that skew numbers.
Testing 6 min

IoT alerting that operators do not learn to ignore

Practical IoT alerting design for connected fleets: offline detection, hysteresis, grouping and routing so operators act instead of muting.
Software 7 min

Choosing a 4-layer PCB stackup for connected devices

How to choose a 4-layer PCB stackup for a small connected device: layer order, trace impedance, radio keep-outs and what to tell the fab.
Hardware 6 min

Embedded unit testing without the target hardware

Embedded unit testing on a laptop catches firmware logic bugs in seconds. How to structure code, pick tools and know what still needs the board.
Firmware 7 min

Running a hardware design review before you order boards

How we run a hardware design review before ordering boards: who should attend, what to check in schematic and layout, and how to track fixes.
Process 7 min

Screw boss design for plastic electronics enclosures

Practical screw boss design for plastic enclosures: wall ratios, pilot holes, inserts versus thread-forming screws, and how to test before tooling.
Design 7 min
Load more — 38 older posts