The Milo journal: short, practical write-ups on hardware, firmware and shipping connected products, from an engineering studio in Bar, Montenegro. Topic: Hardware.

Journal / HardwareNotes from the bench

Hardware.

Short, practical write-ups on hardware, firmware and shipping products — published a few times a week from the bench in Bar.

7 posts

Choosing a 4-layer PCB stackup for connected devices

How to choose a 4-layer PCB stackup for a small connected device: layer order, trace impedance, radio keep-outs and what to tell the fab.
Hardware 6 min

Li-ion charging circuit design for small devices

How to design a Li-ion charging circuit for a one-cell device: CC/CV stages, linear vs switching, power path, temperature limits and bench tests.
Hardware 6 min

ESD protection design for small connected devices

Practical ESD protection design for small devices: find the entry points, choose and place TVS diodes, and make firmware recover before the lab.
Hardware 6 min

USB-C power input design for small devices

Design a USB-C power input that works with every charger and cable: CC resistors, protection, inrush, charger choice and when PD is worth it.
Hardware 6 min

PCB antenna placement for small connected devices

Getting PCB antenna placement right matters more than the radio chip: edge position, keep-out, matching networks and tuning inside the real enclosure.
Hardware 7 min

ESP32 vs STM32: choosing for a connected product

ESP32 vs STM32 for a connected product: how we weigh radio, power, analogue, security and supply before choosing a microcontroller.
Hardware 7 min

Where the microamps really go in low-power design

Good low-power design is mostly leak hunting: regulator quiescent draw, pull-ups, floating pins and the sensor that never sleeps. Where we look first.
Hardware 7 min
Load more — 0 older posts